Category: QUESTIONS & ANSWERS
How to distinguish between amplifiers and comparators?
* Question
How to distinguish between amplifiers and comparators?
* Answer
The difference between the op amp and the comparator: Although th [...]
What is the self-plus 1 / minus 1 instruction?
* Question
What is the self-plus 1 / minus 1 instruction?
* Answer
The self-adding l/minus l instruction INC/DEC is used to increment/decrem [...]
What are the benefits of using subcarrier modulation in RFID systems?
* Question
What are the benefits of using subcarrier modulation in RFID systems?
* Answer
Each time the debug tube has a short on-time, the [...]
What types of impulse noise are there?
* Question
What types of impulse noise are there?
* Answer
(1) The periodic impulse noise of a synchronous AC power source is a type of nois [...]
Problems that should be paid attention to during the operation of current transformer
* Question
Problems that should be paid attention to during the operation of current transformer
* Answer
(1) The current transformer shall [...]
The quality of the UWSN node deployment plan mainly focuses on several indicators?
* Question
The quality of the UWSN node deployment plan mainly focuses on several indicators?
* Answer
1) Coverage performance of the target [...]
What are the development trends of RFID electronic tags?
* Question
What are the development trends of RFID electronic tags?
* Answer
(1) The cost is lower.From the development of electronic tags, [...]
Sensor selection technique
* Question
Sensor selection technique
* Answer
Sensor Selection Techniques Modern sensors vary widely in principle and structure. How to pro [...]
What is the beam divergence angle?
* Question
What is the beam divergence angle?
* Answer
The beam divergence angle is an indicator that can be measured in the far field, and [...]
How to maintain TOUT at high/low level (assuming the reverse bit has been turned off)?
* Question
How to maintain TOUT at high/low level (assuming the reverse bit has been turned off)?
* Answer
The auto-reload bit is turned off [...]